LC-1 Two wideband Analog signals?
#1
Banned
Thread Starter
Join Date: 09-27-06
Location: FL
Posts: 1,084
Likes: 0
Received 0 Likes
on
0 Posts
LC-1 Two wideband Analog signals?
Hey guys,
I need two analog signals for wideband output.
One is to hook to HP Tuners and the other is for my wideband gauge.
Is this possible and how?
I need two analog signals for wideband output.
One is to hook to HP Tuners and the other is for my wideband gauge.
Is this possible and how?
#4
Banned
Thread Starter
Join Date: 09-27-06
Location: FL
Posts: 1,084
Likes: 0
Received 0 Likes
on
0 Posts
Aeroforce interceptor Gauge and I bought a Innovative analog afr gauge which is coming soon. Thus one analog is used (the brown wire / wideband output) the other analog on the LC-1 is Narrow band and can't be changed?
#6
Banned
Thread Starter
Join Date: 09-27-06
Location: FL
Posts: 1,084
Likes: 0
Received 0 Likes
on
0 Posts
Not Wideband, I don't even think it does Narrowband.
Only way to display wideband on interceptor is to run one of the analog inputs off the interceptor to the wideband output of the LC-1.
Only way to display wideband on interceptor is to run one of the analog inputs off the interceptor to the wideband output of the LC-1.
#10
Senior Member
Join Date: 11-11-05
Location: Oceanside, Ca
Posts: 9,438
Likes: 0
Received 0 Likes
on
0 Posts
I use the xd-16 and hptuners, very simple setup.
I've done one interceptor setup, took about 5 minutes.
I know of a few people that have used the same sensor while loggin wide and narrow band....but not sure about going from narrow to wideband.
Last edited by Doc; 05-13-2008 at 08:34 PM. Reason: Automerged Doublepost
Thread
Thread Starter
Forum
Replies
Last Post
2.0 LSJ Engine: aem wideband,zzp front mount exhanger,stock exchanger
n20saturn
Parts
7
09-30-2015 12:26 AM