I got my intake apart. I think my MAF sensor is a bit dirty. I bought some cleaner and am spraying the **** out of the intake. But I don't see the sensor.

Is it behind the TB?? I didn't think it was....

Is it so low in the intake that I have to take the wheel off to get at it.

I don't feel like jacking the car up[ and taking the wheel off but if thats the only way, I have to do what I have to do.

I'm almost positive that its dirty because there is gunk all up near my throttle body and right where the Z bends are in the intake.

I have stock intake w/ box mod and OILED cone filter which I put in about 16k ago.

ANY HELP APPRECIATED!!!!

 

Its in the lower part of the intake, in the bumper. I think you could get it out by popping out the headlight and bracket.

 

It's the connecter right after your cone filter, like the only wires that go to the intake between the cone filter and the TB.

 

Bump... do I need to take the wheel off????

 

Easiet way is to take off the wheel, remove the plastic wheel well piece and then you will be able to remove the intake/MAF. Use MAF cleaner on it and you should be fine.

 

oh...crap im a *******.....just noticed you are 2.0... my bad