Official TVS Thread!!!
#5864
Junior Member
iTrader: (1)
Allrighty
Tuesday after my diagnostic class I swung by Stiegemeier and let them crack the case open, they dont charge for that; Took about 3minutes.
The needle bearings in the case are shot; He said I was close to having a badass paperweight.
The rotor shafts were slightly grooved, but not bad at all; And some scoring on the walls
The guys were very surprised that the bearings took a **** at only 30Kish miles on 3.14 pulley
While the TVS is getting rebuilt, I went ahead and pulled off the head ordered LZM delete kit, supertechs, TTY bolts and other necessary parts.
Tuesday after my diagnostic class I swung by Stiegemeier and let them crack the case open, they dont charge for that; Took about 3minutes.
The needle bearings in the case are shot; He said I was close to having a badass paperweight.
The rotor shafts were slightly grooved, but not bad at all; And some scoring on the walls
The guys were very surprised that the bearings took a **** at only 30Kish miles on 3.14 pulley
While the TVS is getting rebuilt, I went ahead and pulled off the head ordered LZM delete kit, supertechs, TTY bolts and other necessary parts.
#5867
Former Vendor
iTrader: (3)
Allrighty
Tuesday after my diagnostic class I swung by Stiegemeier and let them crack the case open, they dont charge for that; Took about 3minutes.
The needle bearings in the case are shot; He said I was close to having a badass paperweight.
The rotor shafts were slightly grooved, but not bad at all; And some scoring on the walls
The guys were very surprised that the bearings took a **** at only 30Kish miles on 3.14 pulley
While the TVS is getting rebuilt, I went ahead and pulled off the head ordered LZM delete kit, supertechs, TTY bolts and other necessary parts.
Tuesday after my diagnostic class I swung by Stiegemeier and let them crack the case open, they dont charge for that; Took about 3minutes.
The needle bearings in the case are shot; He said I was close to having a badass paperweight.
The rotor shafts were slightly grooved, but not bad at all; And some scoring on the walls
The guys were very surprised that the bearings took a **** at only 30Kish miles on 3.14 pulley
While the TVS is getting rebuilt, I went ahead and pulled off the head ordered LZM delete kit, supertechs, TTY bolts and other necessary parts.