Official TVS Thread!!!
#9026
#9028
Rent me! per hour
Join Date: 03-22-07
Location: Still fixing others mistakes.
Posts: 24,185
Likes: 0
Received 20 Likes
on
14 Posts
if you can't read a plug, or know when to do it, you shouldn't be tuning a car. period. You can shove 32 degree's of timing up it's ass and wing it and see what happens....
#9029
I logged the car so he could see of there was any changes that needed to be made.
other than that I just drove the car.
#9031
Rent me! per hour
Join Date: 03-22-07
Location: Still fixing others mistakes.
Posts: 24,185
Likes: 0
Received 20 Likes
on
14 Posts
I never said I was tuning Steves car all I did was pull some timing out befor hitting the car with nitrous to be on the safe side if something were to hickup.
I logged the car so he could see of there was any changes that needed to be made.
other than that I just drove the car.
I logged the car so he could see of there was any changes that needed to be made.
other than that I just drove the car.
#9035
#9036
#9038
All I did with steves tune was -5 from the whole table. not rocket science.
I'm just the wrench monkey here.
Last edited by Tjolley; 07-31-2014 at 05:51 PM.
#9043
I know it's been covered but I'm on my phone (laptop needs fixed) but I'm dropping pulley size soon, how small can I go on stock belt/how small on the gms2 belt. Would it be efficient to do 2.7 or should I not go that low. I've read something about 2.9 being best. What else will I need, belt/tensioner(?) to make it work.
I'm putting my front mount intercooler on soon and getting the car tuned/dynod but I would like to drop pulley before doing that.
I'm putting my front mount intercooler on soon and getting the car tuned/dynod but I would like to drop pulley before doing that.
#9044
Senior Member
iTrader: (3)
I know it's been covered but I'm on my phone (laptop needs fixed) but I'm dropping pulley size soon, how small can I go on stock belt/how small on the gms2 belt. Would it be efficient to do 2.7 or should I not go that low. I've read something about 2.9 being best. What else will I need, belt/tensioner(?) to make it work. I'm putting my front mount intercooler on soon and getting the car tuned/dynod but I would like to drop pulley before doing that.