stroker lsj build
#703
Senior Member
Thread Starter
Ok so i dropped the rotating assembly off last night.
The shop was so sick. He mainly balances jet engines for for Boeing and Rolls Royce. It was cool to see a big ass jet turbine sitting there. Im looking forward to getting this engine running.
The shop was so sick. He mainly balances jet engines for for Boeing and Rolls Royce. It was cool to see a big ass jet turbine sitting there. Im looking forward to getting this engine running.
#704
Senior Member
Thread Starter
Went over to balance Technologies last night to see how it all was doing.
Tom was working on my stuff and said it will be ready late today or monday for sure.
Wish i could have taken some pictures but didnt want to disrespect the guy.
So now i will have a spare 2.4 crank if anyone is interested ill post a FS thread after my build is complete.
Tom was working on my stuff and said it will be ready late today or monday for sure.
Wish i could have taken some pictures but didnt want to disrespect the guy.
So now i will have a spare 2.4 crank if anyone is interested ill post a FS thread after my build is complete.
#707
Senior Member
Thread Starter
Few weeks.
I could have it done next week if i wanted to but im not in any hurry at all. I work 70-80 hrs a week so not much time at all.
And im building another engine for another car right now also that will be done before the cobalt.
I could have it done next week if i wanted to but im not in any hurry at all. I work 70-80 hrs a week so not much time at all.
And im building another engine for another car right now also that will be done before the cobalt.
#712
Senior Member
Thread Starter
My thoughts
A rough intake port is more helpful in a carbureted naturally aspirated application.
Most of us here are supercharged or turbocharged and we are fuel injected. Our fuel gets sprayed a third of the way into the port. So I think you're going to get all the atomisation from the turbulence air and the fuel injector. So I would rather have a perfectly smooth intake port.
These are my thoughts from what I have gathered myself.
A rough intake port is more helpful in a carbureted naturally aspirated application.
Most of us here are supercharged or turbocharged and we are fuel injected. Our fuel gets sprayed a third of the way into the port. So I think you're going to get all the atomisation from the turbulence air and the fuel injector. So I would rather have a perfectly smooth intake port.
These are my thoughts from what I have gathered myself.
#719
Senior Member
Thread Starter
#720
Senior Member
Thread Starter
Just picked everything up from balance technology it all turned out so sick i can't wait.
He balanced the crank pulley bolt, flywheel bolts, pressure plate bolts. I thought he was crazy wen he said he did all that.
He even balanced the clutch disk and the pressure plate.
Its all balanced within 0.002 inch grams (whatever that means).
He balanced the crank pulley bolt, flywheel bolts, pressure plate bolts. I thought he was crazy wen he said he did all that.
He even balanced the clutch disk and the pressure plate.
Its all balanced within 0.002 inch grams (whatever that means).
#722
Senior Member
Thread Starter
My first engine wasn't balanced. It ran fine u just get stuck with all the vibration. Not much more than stock if any.I don't think u will spend as much time above 6000 rpm as i plan to.