2.2L hahn turbo
#26
Senior Member
Join Date: 12-23-06
Location: York, PA
Posts: 1,500
Likes: 0
Received 0 Likes
on
0 Posts
i have the SMT-6 along with the setup for the 5th injector at 60lb-hr
i am not looking to boost too much, but not sure that this setup is safe or will even work at all.
i am not looking for huge power gains, only safe for the moment until better tuning is available.
i am not looking to boost too much, but not sure that this setup is safe or will even work at all.
i am not looking for huge power gains, only safe for the moment until better tuning is available.
Last edited by 07cobaltowner; 07-23-2007 at 03:18 PM. Reason: Automerged Doublepost
#27
New Member
Join Date: 09-28-06
Location: Providence, RI
Posts: 78
Likes: 0
Received 0 Likes
on
0 Posts
i have the SMT-6 along with the setup for the 5th injector at 60lb-hr
i am not looking to boost too much, but not sure that this setup is safe or will even work at all.
i am not looking for huge power gains, only safe for the moment until better tuning is available.
i am not looking to boost too much, but not sure that this setup is safe or will even work at all.
i am not looking for huge power gains, only safe for the moment until better tuning is available.
I didn't like the SMT-6 too much because it's uses alpha-n (TPS vs RPM) Where it should use speed density (MAP vs RPM)
I personally would use the 034 EIC
link:
http://www.034motorsport.com/product...products_id=71
#28
Senior Member
Join Date: 09-25-06
Location: USAG Stuttgart, GER
Posts: 1,860
Likes: 0
Received 0 Likes
on
0 Posts
I didn't like the SMT-6 too much because it's uses alpha-n (TPS vs RPM) Where it should use speed density (MAP vs RPM)
I personally would use the 034 EIC
link:
http://www.034motorsport.com/product...products_id=71
I personally would use the 034 EIC
link:
http://www.034motorsport.com/product...products_id=71
Thread
Thread Starter
Forum
Replies
Last Post