CAI using stock parts+extra pipe
#1
CAI using stock parts+extra pipe
been seeing alot of these custom intake mods, just thought i'd throw mine is aswell...i had this setup before my inner fender wall went missin(it flew off b/c my genious gf didnt bolt it on right)...but basically, all i did was follow the 2.2 airbox mod and add a coupler and a pipe with a filter to it and wammo presto...CAI...no codes, no problems...
engine bay
the gap the pipe goes thru(breather was on there for show only)
view thru the fender
engine bay
the gap the pipe goes thru(breather was on there for show only)
view thru the fender
Last edited by Jn2; 06-28-2007 at 02:48 AM. Reason: spell check
#2
Senior Member
Join Date: 02-27-06
Location: Rochester, NY
Posts: 926
Likes: 0
Received 0 Likes
on
0 Posts
Nice but that silencer on top of the engine is still a bottleneck in the system and an intake system is just like an exhaust system in a sense that it's only as good as it's narrowest component
#3
alright i just checked up this thread i started awhile ago...apperantly my geocities account sucks, so the pics aent gunna show...b/c i exceeded my data transer...so to make it a bit easier i'll just show the part i have saved on my comp, which is
but basically all you do is put the coupler on the MAF adapter thing than after the coupler put the pipe and the filter, clamp down, and there you go...
but basically all you do is put the coupler on the MAF adapter thing than after the coupler put the pipe and the filter, clamp down, and there you go...
Thread
Thread Starter
Forum
Replies
Last Post