finshed 2.2 super charged @ 10 psi
#276
Senior Member
i have the videos and im going to meet with matt to post them for ya. keep all rude coments to self or these will be my last post!!!! i dont have to share my info with yall and i dont need the coments. i KNOW ITS GOING TO BLOW AND I WILL EVEN SHOW ME BLOWING IT UP but right know i still need the engine for a few more datalogs and mods to see what the stock computer will do
#279
Senior Member
#280
Senior Member
Thread Starter
yes i am going to blow it up. after a few tunes and mods. my goal is to have it tuned perfic with the smt7 and just hammer on it in till it pops but i will pop it at the local dragstrip doing 1/8 mile runs and see what happens then ill use my core engine and build it with my H-beam rods and forged pistons new head studs and gasket retune it and there we have it a vid of what will happen if you do this and that. yea i know im crazy bt who else will do this ??? no one in there right mind ps. if it holds to gether then we all will know first hand how much it will take and what will happen if someone else were to try this
#281
yes i am going to blow it up. after a few tunes and mods. my goal is to have it tuned perfic with the smt7 and just hammer on it in till it pops but i will pop it at the local dragstrip doing 1/8 mile runs and see what happens then ill use my core engine and build it with my H-beam rods and forged pistons new head studs and gasket retune it and there we have it a vid of what will happen if you do this and that. yea i know im crazy bt who else will do this ??? no one in there right mind ps. if it holds to gether then we all will know first hand how much it will take and what will happen if someone else were to try this
#282
yes i am going to blow it up. after a few tunes and mods. my goal is to have it tuned perfic with the smt7 and just hammer on it in till it pops but i will pop it at the local dragstrip doing 1/8 mile runs and see what happens then ill use my core engine and build it with my H-beam rods and forged pistons new head studs and gasket retune it and there we have it a vid of what will happen if you do this and that. yea i know im crazy bt who else will do this ??? no one in there right mind ps. if it holds to gether then we all will know first hand how much it will take and what will happen if someone else were to try this
#283
I'm old school
If you have a core engine, don't wait to build it until the first one blows. You should have your core built and wrapped in plastic, ready to go the instant you need it. Otherwise, you might as well just fix the engine you blow.
#286
Senior Member
Join Date: 06-06-06
Location: Redding, Nor-Cal.
Posts: 2,889
Likes: 0
Received 0 Likes
on
0 Posts
I still dont under stand why people are flaming, espically the 2.2 people!! This is great that he has the ***** to do seomething that many people have shot down as not being possible at all. We all know that all of our engines are dam near the same so why doubt that all this **** is possible. All the best luck Yellow!
Its another case of; "he is doing something different, lets flame him guys!"
Its another case of; "he is doing something different, lets flame him guys!"
#288
Senior Member
iTrader: (1)
of course it's the ss.net way man. You should know that by now.
anyway... when's this new vid gonna be up. I put $20 on it having an exploding engine in it.
not flaming. but I don't think the 2.2 is gonna take 14psi of non-intercooled boost and uncontrolled fuel. But I've seen engines hold up to worse, so we shall see. (stock monte ss 305 h.o. V8... 250 shot 225,000 miles, made 3 runs then finally grenaded)
anyway... when's this new vid gonna be up. I put $20 on it having an exploding engine in it.
not flaming. but I don't think the 2.2 is gonna take 14psi of non-intercooled boost and uncontrolled fuel. But I've seen engines hold up to worse, so we shall see. (stock monte ss 305 h.o. V8... 250 shot 225,000 miles, made 3 runs then finally grenaded)
#289
of course it's the ss.net way man. You should know that by now.
anyway... when's this new vid gonna be up. I put $20 on it having an exploding engine in it.
not flaming. but I don't think the 2.2 is gonna take 14psi of non-intercooled boost and uncontrolled fuel. But I've seen engines hold up to worse, so we shall see. (stock monte ss 305 h.o. V8... 250 shot 225,000 miles, made 3 runs then finally grenaded)
anyway... when's this new vid gonna be up. I put $20 on it having an exploding engine in it.
not flaming. but I don't think the 2.2 is gonna take 14psi of non-intercooled boost and uncontrolled fuel. But I've seen engines hold up to worse, so we shall see. (stock monte ss 305 h.o. V8... 250 shot 225,000 miles, made 3 runs then finally grenaded)
#290
Senior Member
iTrader: (1)
11.8, 11.65, 11.66 @115-117mph.... on slicks of course with 1.5-1.66 short times.
with the last motor (.60 over 350) with a 2-stage 400hp nitrous setup, it went 9:56 @144mph (was hitting off the limiter at the 1000' mark though) and then I got thrown outta the track for no cage, harness, well pretty much only had a helmet lol.
with the last motor (.60 over 350) with a 2-stage 400hp nitrous setup, it went 9:56 @144mph (was hitting off the limiter at the 1000' mark though) and then I got thrown outta the track for no cage, harness, well pretty much only had a helmet lol.
#291
Senior Member
Join Date: 06-06-06
Location: Redding, Nor-Cal.
Posts: 2,889
Likes: 0
Received 0 Likes
on
0 Posts
#293
#294
Senior Member
I still dont under stand why people are flaming, espically the 2.2 people!! This is great that he has the ***** to do seomething that many people have shot down as not being possible at all. We all know that all of our engines are dam near the same so why doubt that all this **** is possible. All the best luck Yellow!
Its another case of; "he is doing something different, lets flame him guys!"
Its another case of; "he is doing something different, lets flame him guys!"
#295
Senior Member
Thread Starter
ok i have the vids and yall will see what happens "it can go ether way" im waiting on matt to get here then they will be up like promised BTW i have another block ready to go
#298
Senior Member
Join Date: 05-17-06
Location: Missouri
Posts: 520
Likes: 0
Received 0 Likes
on
0 Posts
yes i am going to blow it up. after a few tunes and mods. my goal is to have it tuned perfic with the smt7 and just hammer on it in till it pops but i will pop it at the local dragstrip doing 1/8 mile runs and see what happens then ill use my core engine and build it with my H-beam rods and forged pistons new head studs and gasket retune it and there we have it a vid of what will happen if you do this and that. yea i know im crazy bt who else will do this ??? no one in there right mind ps. if it holds to gether then we all will know first hand how much it will take and what will happen if someone else were to try this
You younger guys sure do engine tunes differently than the older days....
#299
Senior Member
Join Date: 06-06-06
Location: Redding, Nor-Cal.
Posts: 2,889
Likes: 0
Received 0 Likes
on
0 Posts
#300
Senior Member
Join Date: 03-03-06
Location: Pittsburgh, PA
Posts: 4,958
Likes: 0
Received 0 Likes
on
0 Posts
If you think about his setup, its really no different than an fpr and missing link combo. The stock fuel trim system and larger injectors take the place of the fpr but accomplish the same thing. Moving the map before the supercharger is doing the same as what a missing link does.