Found out what my problem is...
#1
Senior Member
Thread Starter
iTrader: (1)
Join Date: 07-27-07
Location: Puyallup, WA
Posts: 17,332
Likes: 0
Received 0 Likes
on
0 Posts
Found out what my problem is...
Sorry for the big pics...but im sure you can all figure it out...
ya...all the exhaust valves are bent...
cyl looks ok, you can see where it impacted but because it was only as fast as the starter was turning it its ok...
will update my build thread as it goes: https://www.cobaltss.net/forums/2-2l-l61-performance-tech-45/toms-build-d-155396/
and some more pics..
and this is where i get to work on the car lol
ya...all the exhaust valves are bent...
cyl looks ok, you can see where it impacted but because it was only as fast as the starter was turning it its ok...
will update my build thread as it goes: https://www.cobaltss.net/forums/2-2l-l61-performance-tech-45/toms-build-d-155396/
and some more pics..
and this is where i get to work on the car lol
#6
Senior Member
Thread Starter
iTrader: (1)
Join Date: 07-27-07
Location: Puyallup, WA
Posts: 17,332
Likes: 0
Received 0 Likes
on
0 Posts
i learned the hard way...but i have to say, i learned a hell of alot about the engine and how it all works in general while doing this...
just wish it would have been my choice
ya lol, the right side valves are supposed to look like the left in that they should seat all the way
Last edited by NWAE Cobalt; 03-31-2009 at 09:47 PM. Reason: Automerged Doublepost
Thread
Thread Starter
Forum
Replies
Last Post