im board
#1
Senior Member
Thread Starter
iTrader: (1)
Join Date: 07-13-08
Location: wyomin
Posts: 2,048
Likes: 0
Received 0 Likes
on
0 Posts
im board
i need to do some thin to the cobalt but i dont now what to do i have mostly all bolt on's, i had a chip but missed my **** up so what can i do for a next project, i have k&n intake, 2.5 catback,b&m short throw, sub, rims, 2.4 intake man, blacked my headlights and rear, did the same to my symbols, and thats about it so help me out i need to put somethin else on this dam thing mostly something for hp NO NOS!!!!!
#7
Senior Member
Join Date: 01-09-07
Location: Cincinnati, OH
Posts: 3,776
Likes: 0
Received 0 Likes
on
0 Posts
#13
Senior Member
Thread Starter
iTrader: (1)
Join Date: 07-13-08
Location: wyomin
Posts: 2,048
Likes: 0
Received 0 Likes
on
0 Posts
i was under warrenty, so i just played dumb (not hard to do) and got her fixed. i've had it back for about three days. i sent the chip back to get my money$$$$$$$$$$$$$$$$
i want to lower it thats a for sure thing.
i want to lower it thats a for sure thing.
Last edited by scotch89; 08-06-2008 at 08:32 PM. Reason: Automerged Doublepost
#14
Senior Member
Join Date: 08-09-07
Location: minnesota
Posts: 1,619
Likes: 0
Received 0 Likes
on
0 Posts
i need to do some thin to the cobalt but i dont now what to do i have mostly all bolt on's, i had a chip but missed my **** up so what can i do for a next project, i have k&n intake, 2.5 catback,b&m short throw, sub, rims, 2.4 intake man, blacked my headlights and rear, did the same to my symbols, and thats about it so help me out i need to put somethin else on this dam thing mostly something for hp NO NOS!!!!!
edited for clarity. now people can help you.
and to answer your question, you have listed most of the obvious bolt-ons and there isn't much left to do except full exhaust. That is if your not looking into power-adders n20 has been shown to make 2.2's quite quick. If you have any question about it ask HackAbuse hes the local N20 and street racing *****.
#16
Thread
Thread Starter
Forum
Replies
Last Post
satisfied
Problems/Service/Maintenance
3
10-19-2015 12:35 AM