MP Cobalt

iTrader: (4)

id onlt run it on stage 2 when i race. thanks bro im going to hav to do this all over again 2morrow. thanks again for the help.

mrsilent13

no prob....anytime...we all here to share

MP Cobalt

iTrader: (4)

o one last question when you striped the blue and red wires how did you do it without cutting them?

mrsilent13

razor blade, take it slow so u dont cut the actuall wires

MasterMike

I ordered mine last week and waiting for it..And i ordered the tranny mounts from Turbo Tech...Can't wait to install them!

mrsilent13

i might have to get some tranny mounts....how much do does run...i havent looked into it

MP Cobalt

iTrader: (4)

Yea i was going to say because those wires are smaller than the worlds smallest violin. I need to find a good spot for the little switch box somewhere nice

jigyflyuk07

yea, what tranny mounts you get?

mrsilent13

yea i know what ur talkin about i was actually going to put it right below my head unit but i already have switch there for my neons or else it would have gone there......but for now its going to stay above the steering

MP Cobalt

iTrader: (4)

If my gay double sided tape would stay i would put it down under by where the little emissions plug is at. Somewhere hidden but looks like it goes there.

OrngBalt

A bunch of us have taken it and put it under the steering wheel. just lift it up and stick it between the console and the wheel and then lower it down to hold it in place

MP Cobalt

iTrader: (4)

Yea i hate the wheel being up higher though i like it the whole way down. Ill superglue it down there if i got to

MasterMike

https://www.turbotechracing.com/prod...idproduct=5068

mrsilent13

well i put it on top of the steering...it looks good...u cant really see it unless u looking for it......and the wheel sits low just how i like it......

OrngBalt

It doesnt make a difference. The console under the wheel actually gives a little so you end up having the wheel no more than a 1/4" higher. you can push it down more.