i dont know what the f*ck im doing
#1
Member
Thread Starter
Join Date: 11-05-10
Location: kentucky
Posts: 235
Likes: 0
Received 0 Likes
on
0 Posts
i dont know what the f*ck im doing
alright guys, i am just trying to hook up some light bars for my footwells. got the bars mounted, switched wires, and got them grounded, hooked a fuse tap into my fuse box, and nothing happened. my wiring is good. i just cant figure out what went wrong. i know im a noob so flame away lol
#6
Member
Thread Starter
Join Date: 11-05-10
Location: kentucky
Posts: 235
Likes: 0
Received 0 Likes
on
0 Posts
i tapped it into the wiper fuse. and yes i turned the key on lol. wipers work but no lights. the lights worked fine when i tested them. the fuse tap in using has 2 slots. is there suppose to be 2 fuses in it?
#7
Senior Member
Tap into the parking lights. That's what I did on my 2.4L
#10
Member
Thread Starter
Join Date: 11-05-10
Location: kentucky
Posts: 235
Likes: 0
Received 0 Likes
on
0 Posts
i will try that tomorrow and see if it works
switch is fine lol. it just acts like its not getting power. i have a switch that has power in and out and a negative for the led on it.
switch is fine lol. it just acts like its not getting power. i have a switch that has power in and out and a negative for the led on it.
#11
yes if theres 2 slots u gotta use 2 fuses, i think i used the same fuse tap as u, it should come with some did it not?
#13
Member
Thread Starter
Join Date: 11-05-10
Location: kentucky
Posts: 235
Likes: 0
Received 0 Likes
on
0 Posts
#14
#18
#19
Senior Member
if your using the wiper fuse, then you put the wiper fuse in the bottom slot and thefuse for your leds or whatevr in the top slot, i dunno what amp fuse runs the wipers butif its just leds then you might not need a fuse as high, probably only a seven amp one will work but if it blows just up the fuse to a higher one lol