Kenwood DNX9140 in '08 LT
#1
New Member
Thread Starter
Kenwood DNX9140 in '08 LT
I just picked up a Kenwood DNX9140 HU, and going to have it installed soon hopefully (still need to get my front comps/amp).
The car is a lease... and I don't have OnStar or the Pioneer system... so what harness(es) would I need (if any) if I end up not buying out at the end? I want to be able to put the factory deck back w/o much hassle, with the very least amt of wire hacking. I am also not too worried about retaining chimes and steering controls if it means not hacking stuff up too much.
This is what I have so far along with an Alpine MRP-M1000 amp. The box maker apparently makes them to Type-R specs, Hammermill (sp?). The only Hammermill I know makes paper.
The car is a lease... and I don't have OnStar or the Pioneer system... so what harness(es) would I need (if any) if I end up not buying out at the end? I want to be able to put the factory deck back w/o much hassle, with the very least amt of wire hacking. I am also not too worried about retaining chimes and steering controls if it means not hacking stuff up too much.
This is what I have so far along with an Alpine MRP-M1000 amp. The box maker apparently makes them to Type-R specs, Hammermill (sp?). The only Hammermill I know makes paper.
Thread
Thread Starter
Forum
Replies
Last Post