speaker enclosure part number?
#1
New Member
Thread Starter
Join Date: 05-05-07
Location: PA
Posts: 99
Likes: 0
Received 0 Likes
on
0 Posts
speaker enclosure part number?
Anybody with the pioneer 7 speaker audio system (or anybody else I guess) happen to know the part number for the 10" speaker enclosure? (Or if it's even available from GM for that matter)
It looks like a rather convenient spot to mount one of my rockford p2 10"'s and would be awesome if i could order one.
(I searched, but only found posts with people looking for the speaker part number itself - and there weren't any answers for that either.)
It looks like a rather convenient spot to mount one of my rockford p2 10"'s and would be awesome if i could order one.
(I searched, but only found posts with people looking for the speaker part number itself - and there weren't any answers for that either.)
#5
Senior Member
#6
New Member
Thread Starter
Join Date: 05-05-07
Location: PA
Posts: 99
Likes: 0
Received 0 Likes
on
0 Posts
#7
Senior Member
#8
New Member
Thread Starter
Join Date: 05-05-07
Location: PA
Posts: 99
Likes: 0
Received 0 Likes
on
0 Posts
Since you have the box and have seen how it looks when pulled perhaps you'll be able to give me an opinion. Do you think it'll hold a "beefier" 10" sub or do you think it's more of a "it'll fit this speaker and not too much else" type of situation.
Reason I ask is because right now i'm running a rockford p3002 amp and a single 8ohm rockford p2 10" sub.
If i were to leave the pioneer in there, the 2+2 voice coils would have me at a 4 ohm load effectively doubling my wattage to about 300RMS. (More than that pioneer speaker is meant to handle (i think - i haven't seen any stats on it) but throwing in a beefier 10" sub may not even be possible.
Thanks again.
Thread
Thread Starter
Forum
Replies
Last Post