Mark this thread as Unsold
All U Vis Cf Hood Owners
#1
Senior Member
Thread Starter
Join Date: 03-07-06
Location: Bronx, NY
Posts: 871
Likes: 0
Received 0 Likes
on
0 Posts
All U Vis Cf Hood Owners
I have a question on the VIS CF Hood. I just got mine yesterday and i put it on 2day but for some reason there seems so be a small gap (about half and inch or so) between the fendor and the hood on each side. Also when looking at the car from the fron there seems the left side seemd to sit up higher towards the windshield. Has any ones else encounterd such problems? if so can you guys let me know what i can do to fix it?
#3
Senior Member
you didnt think it would fit perfect out of the box did you? lol
grab your wrench and start adjusting.
You can move your front fenders in just a touch by loosening the bolts under the hood to tighten up those gaps on the sides....loosen and move the hinge bolts to adjust your angle etc etc.
its just gonna take a little time and effort to get it right.
grab your wrench and start adjusting.
You can move your front fenders in just a touch by loosening the bolts under the hood to tighten up those gaps on the sides....loosen and move the hinge bolts to adjust your angle etc etc.
its just gonna take a little time and effort to get it right.
#4
Junior Member
Join Date: 06-02-06
Location: Richmond, Va
Posts: 438
Likes: 0
Received 0 Likes
on
0 Posts
I have a question on the VIS CF Hood. I just got mine yesterday and i put it on 2day but for some reason there seems so be a small gap (about half and inch or so) between the fendor and the hood on each side. Also when looking at the car from the fron there seems the left side seemd to sit up higher towards the windshield. Has any ones else encounterd such problems? if so can you guys let me know what i can do to fix it?
#5
Junior Member
Join Date: 05-28-07
Location: Washington
Posts: 462
Likes: 0
Received 0 Likes
on
0 Posts
you can also adjust the hood by repositioning the latch higher or lower according to your needs...
there are rubber mounts that support your hood that you can twist in and out. this will cause the opposite side of the hood to move up and down.
just play with it for a little it takes some time to get it just right.
there are rubber mounts that support your hood that you can twist in and out. this will cause the opposite side of the hood to move up and down.
just play with it for a little it takes some time to get it just right.
#9
Senior Member
Join Date: 10-11-06
Location: Easton, PA
Posts: 531
Likes: 0
Received 0 Likes
on
0 Posts
its not the hood its the hood stand its ment to hold are heavy ass hoods so it push up on the hood when its closed so what you have to do is take it out got to the junk yard and fin a hood stand or just live with it
Thread
Thread Starter
Forum
Replies
Last Post