Mark this thread as Unsold
FS Ingalls ETD
#1
Senior Member
Thread Starter
iTrader: (4)
Join Date: 10-12-08
Location: Grand Blanc, Michigan
Posts: 1,198
Likes: 0
Received 0 Likes
on
0 Posts
FS Ingalls ETD
Hey everyone i have a Ingalls ETD for sale. Iv had it on my car for about 3,000 miles and the previous owner had it for about 10,000. The only problem is that its a little chewed up in some places. It does not affect the performance it still works great. There are no bends in the brackes they just need a little clean. I upgraded to TTR solid mount so i have no need for this anymore. If you have any questions just send me a PM. Im looking to get $65 shipped just because of the cosmetic condition.
#4
Senior Member
Thread Starter
iTrader: (4)
Join Date: 10-12-08
Location: Grand Blanc, Michigan
Posts: 1,198
Likes: 0
Received 0 Likes
on
0 Posts
Yes very easy to install. There is a how to its really easy to follow. Took me about 20 min. to install it takes a little time to adjust it tho. PMed you back slobalt08
#10
Senior Member
Thread Starter
iTrader: (4)
Join Date: 10-12-08
Location: Grand Blanc, Michigan
Posts: 1,198
Likes: 0
Received 0 Likes
on
0 Posts
If you look at your stock mount there is two spots were it bolts in. 3 bolts on the engine and two on the frame. Basicly one plate bolts to the Frame and one bolts to the engine. Then the dampner goes in between the plate so when the engine shifts under acceleration the movment is reduced by the dampner.
#20
Senior Member
Thread Starter
iTrader: (4)
Join Date: 10-12-08
Location: Grand Blanc, Michigan
Posts: 1,198
Likes: 0
Received 0 Likes
on
0 Posts
It reduces engine movement on the upper mount. Helps reduce wheel hop and puts more power to the ground. This is the easiest way to reduce movement without replacing the whole mount.
Thread
Thread Starter
Forum
Replies
Last Post