FS: Ported/Polished M62 with ZZP 2.7 and hub
04-01-2008, 05:07 PM
#1
Senior Member
Thread Starter
Join Date: 09-05-07
Location: Sasebo Japan
Posts: 10,662
Likes: 0
Received 0 Likes
on
0 Posts
FS: Ported/Polished M62 with ZZP 2.7 and hub
I'm getting this ready to sell and wanted to post it so people have time to save...i accept paypal u can contact me on here about it..im asking 500 plus a stock blower or 900 outright. its a ported blower and tb with a show polish on the outside of the s/c and tb..as most of u know i am a test pilot for the tvs so i no longer need this no more..the work itself is more than 900..a direct swap over showed that the ported s/c provided 12whp without tuning..lower iat2's and less boost at the same amount of air flow, so it does more than look good. the bearings were repacked and s/c oil is brand new..there are no miles on them as of right now and when its ready to ship out in the next couple weeks it will only have min dyno time on the blower because i have to provide before numbers to harrop.
let me know!!
the whole thing together with show polish
what the blower inlet looked like before port
after port
tb inlet before port
tb after port
let me know!!
the whole thing together with show polish
what the blower inlet looked like before port
after port
tb inlet before port
tb after port
04-01-2008, 06:52 PM
#14
Senior Member
Thread Starter
Join Date: 09-05-07
Location: Sasebo Japan
Posts: 10,662
Likes: 0
Received 0 Likes
on
0 Posts
lol..i guess its easy to sell when u back up what it is and what it does rather than saying..hey buy this
this is sold..can i have someone lock it please!
this is sold..can i have someone lock it please!
Last edited by Raven SS; 04-01-2008 at 06:52 PM. Reason: Automerged Doublepost
Thread
Thread Starter
Forum
Replies
Last Post