Mark this thread as Unsold
For Sale Full 3" CAI LSJ
#1
New Member
Thread Starter
Join Date: 07-27-06
Location: New Hudson, MI
Posts: 139
Likes: 0
Received 0 Likes
on
0 Posts
Full 3" CAI LSJ
Full 3" rebel intake (shortened for 3.5" T/B)- A great piece that is all stainless. However, a hole was tapped into it for the meth injection. Could be easily plugged or welded.
Sold
3.5" T/B - Great item if you are using a full 3" intake. Sold
3.5 " T/B adaptor plate - also from rebel. Sold
http://s1012.photobucket.com/home/shermdog157
Everything is Sold
Sold
3.5" T/B - Great item if you are using a full 3" intake. Sold
3.5 " T/B adaptor plate - also from rebel. Sold
http://s1012.photobucket.com/home/shermdog157
Everything is Sold
Last edited by Meatball; 03-01-2010 at 10:46 AM. Reason: pictures
#7
Senior Member
Join Date: 06-27-05
Location: southeast florida
Posts: 2,058
Likes: 0
Received 0 Likes
on
0 Posts
I'm thinking about it. Does the intake come with everything to hook it up to the ls3/3.5" tb? I didnt know u had to shorten them. How much did u shorten it by? My spacer is only 1/4" thick. and my injen fit the same as with the stock tb besides the fact that I dont have the right coupler for the 3.5" tb.
Also send pics(text, pm, post them) and and any rubbing issues. I dont mind them but prefer not to have them as my injen does.
Also send pics(text, pm, post them) and and any rubbing issues. I dont mind them but prefer not to have them as my injen does.
#8
New Member
Thread Starter
Join Date: 07-27-06
Location: New Hudson, MI
Posts: 139
Likes: 0
Received 0 Likes
on
0 Posts
Yes, I have the adapter and TB for sale also. I also have the 3" coupler to hook it up to the stock throttle body. I used the stock coupler with no issues, just had to make sure to tighten down the clamps good. I will have to check the thickness of the spacer to see how much they shortened the intake, but i think it was about 1-1.5 inches. The intake does not rub at all and even if it did, the stainless is such quality material it would never break the surface.
I try to get you some pics tomorrow morning since i am traveling today.
I try to get you some pics tomorrow morning since i am traveling today.
#16
Rattlesnake Race Shop
iTrader: (1)
Can you email me a picture of the Intake? A picture of the MAF end is preferred. I'm curious as to whether or not I can work it into my Intercooler Piping. That section of piping is a mess on my car.
USMCFieldMP@yahoo.com
USMCFieldMP@yahoo.com