Mark this thread as Unsold
Wanted LNF rockers and lash adjusters
#1
Senior Member
Thread Starter
iTrader: (5)
Join Date: 03-25-11
Location: DFW, Texas
Posts: 1,623
Likes: 0
Received 0 Likes
on
0 Posts
LNF rockers and lash adjusters
Finally did what all the cool kids were and got a taste of the Subaru of death noise. Let me know if anyone has rockers or lash adjusters for cheap
#4
Senior Member
Join Date: 05-15-10
Location: South Charleston, WV
Posts: 3,997
Likes: 0
Received 2 Likes
on
2 Posts
There isn't much for upgrading those unless you want to fork out about 4 grand. What causes them to fail is weak valve springs from overrevving. Get new factory lash adjusters and rockers, then get some ZZP retainers and springs, or just buy mine off of me. Never been used, I'll sell em for 260 shipped. Brand new without shipping, they cost 290. Just bought the ported head and cams combo which comes with valve springs and retainers already installed.
#5
Senior Member
Thread Starter
iTrader: (5)
Join Date: 03-25-11
Location: DFW, Texas
Posts: 1,623
Likes: 0
Received 0 Likes
on
0 Posts
There isn't much for upgrading those unless you want to fork out about 4 grand. What causes them to fail is weak valve springs from overrevving. Get new factory lash adjusters and rockers, then get some ZZP retainers and springs, or just buy mine off of me. Never been used, I'll sell em for 260 shipped. Brand new without shipping, they cost 290. Just bought the ported head and cams combo which comes with valve springs and retainers already installed.
#6
Senior Member
Join Date: 05-15-10
Location: South Charleston, WV
Posts: 3,997
Likes: 0
Received 2 Likes
on
2 Posts
Ok, well, they'll be here. I didn't want to start a thread until I got my engine installed so I could post up my fidanza flywheel since I'm getting a new one with my new engine and other things.
#7
Supporting Vendor
iTrader: (1)
I'll make you a deal on some new ones. Email me zoomer@zzperformance.com
#8
Senior Member
Join Date: 05-19-09
Location: Austin, Texas
Posts: 2,633
Likes: 0
Received 0 Likes
on
0 Posts
#11
Senior Member
Thread Starter
iTrader: (5)
Join Date: 03-25-11
Location: DFW, Texas
Posts: 1,623
Likes: 0
Received 0 Likes
on
0 Posts
I didn't think it was over rev and it doesn't appear to be the case, so far. The rockers and lash adjusters were fine, but I've lost all compression in cylinder 1 and now theyre digging in deeper to find the cause
#14
Senior Member
Join Date: 05-15-10
Location: South Charleston, WV
Posts: 3,997
Likes: 0
Received 2 Likes
on
2 Posts
I'll make you a deal on some new ones. Email me zoomer@zzperformance.com
Thread
Thread Starter
Forum
Replies
Last Post