Parts for Sale
08-02-2010, 07:31 PM
#1
New Member
Thread Starter
Join Date: 06-12-05
Location: NNE Dallas, TX
Posts: 84
Likes: 0
Received 0 Likes
on
0 Posts
Parts for Sale
Got a few things i need to get rid of. i have had them around for a while. Pay Pal works
For sale
1 used Thule Crossroad Rail System for any SUV or car w roof rails
Total retail is $350 to $400 depending where you shop.
Features are:
• Great condition
• Easy to mount.
• Mounts in less than 10 to 15 minutes
• Mounts on any Car or SUV
• Just set on rail, wrap strap under and into slot and then use the t-head allen wrench to tighten and done.
• Tool slides in end so it is always with you and one on every foot.
• Bars can be cut to width of your car or just leave long and swap between cars which is what I did.
• Great for hauling bikes
• Putting a storage bag or a storage box for trips to put in luggage in to make it one comfortable trip.
• Great for just tying items on when you go to local or national lumber store to haul large items on your roof without damaging your roof.
• Used with no problems ever
• Spoiler makes it quiet and more aerodynamic and better mpg
This system consists of 3 Thule items:
450 Crossroad Railing Foot Pack (4 feet included)- Converts existing factory rack with raised side rails into full-featured Thule rack system.
Features
• Built-in tool for easy installation and removal
• Rubber coated steel strap secures foot to siderail
58 inch steel rolled load bars (one pair)
44 inch Fairing- Stylish spoiler helps air to flow over bars for better aerodynamics and quieter ride and less noise under a storage box or rack if used
Features
• Uses a screw on handle for easy mount to load bars
• Rigid construction helps to alleviate wind impact
• Rubber foot to keep from scratching your paint
Box is not included
2.2 or 2.4 ----- 2 inch flex down pipe w gutted cat and pipe welded thru it. it has 2 bungs on it for 02 sensor and anything else you want to put on- $60 plus shipping
Stainless 2.5 in resonator off of a 2009 HHR SS Turbo OEM Exhaust system that had less than 2000 miles on it. $40 plus shipping
I bought the whole system and decided not to use a resonator at all. It has a three bolt flange hook up so it will only work on a SS or a non SS w some modification. All stainless in ready to mount.
could be used to give your stock car more air flow since this was off the SS Turbo.
It could even be a used on other cars w 3 flange mounts or just welded on to fit any vehicle. the resonator is 12 inches long and 18 inches w the extra pipe for fitting.
Ingalls Engine Dampener 93040
engine dampener for 2.2, 2.4 and 2.0 LNF. this has been modified so it bolts right to the engine w no problems. sells new for 191.50 asking $100 shipped
used ECM for 2005-06 hhr/Cobalt LS 2.2 or 06 HHR LS 2.2- $60 shipped
i bought this because i thought my ECM was fried and ended up being ok. It would need to be flashed to your balt or HHR by the dealer or someone that can do tuning.
Arospeed intercooler style front air intake--Asking $60 plus shipping--bought for daughters balt and she bought the K&N intake instead
the item is brand new and never used.
the whole thing is 21 x 6 x 3.25 inches. the filter part is 13.5 by 5 with a 2.25 inch inlet
pm or email me thru the forum if interested in any of the items
For sale
1 used Thule Crossroad Rail System for any SUV or car w roof rails
Total retail is $350 to $400 depending where you shop.
Features are:
• Great condition
• Easy to mount.
• Mounts in less than 10 to 15 minutes
• Mounts on any Car or SUV
• Just set on rail, wrap strap under and into slot and then use the t-head allen wrench to tighten and done.
• Tool slides in end so it is always with you and one on every foot.
• Bars can be cut to width of your car or just leave long and swap between cars which is what I did.
• Great for hauling bikes
• Putting a storage bag or a storage box for trips to put in luggage in to make it one comfortable trip.
• Great for just tying items on when you go to local or national lumber store to haul large items on your roof without damaging your roof.
• Used with no problems ever
• Spoiler makes it quiet and more aerodynamic and better mpg
This system consists of 3 Thule items:
450 Crossroad Railing Foot Pack (4 feet included)- Converts existing factory rack with raised side rails into full-featured Thule rack system.
Features
• Built-in tool for easy installation and removal
• Rubber coated steel strap secures foot to siderail
58 inch steel rolled load bars (one pair)
44 inch Fairing- Stylish spoiler helps air to flow over bars for better aerodynamics and quieter ride and less noise under a storage box or rack if used
Features
• Uses a screw on handle for easy mount to load bars
• Rigid construction helps to alleviate wind impact
• Rubber foot to keep from scratching your paint
Box is not included
2.2 or 2.4 ----- 2 inch flex down pipe w gutted cat and pipe welded thru it. it has 2 bungs on it for 02 sensor and anything else you want to put on- $60 plus shipping
Stainless 2.5 in resonator off of a 2009 HHR SS Turbo OEM Exhaust system that had less than 2000 miles on it. $40 plus shipping
I bought the whole system and decided not to use a resonator at all. It has a three bolt flange hook up so it will only work on a SS or a non SS w some modification. All stainless in ready to mount.
could be used to give your stock car more air flow since this was off the SS Turbo.
It could even be a used on other cars w 3 flange mounts or just welded on to fit any vehicle. the resonator is 12 inches long and 18 inches w the extra pipe for fitting.
Ingalls Engine Dampener 93040
engine dampener for 2.2, 2.4 and 2.0 LNF. this has been modified so it bolts right to the engine w no problems. sells new for 191.50 asking $100 shipped
used ECM for 2005-06 hhr/Cobalt LS 2.2 or 06 HHR LS 2.2- $60 shipped
i bought this because i thought my ECM was fried and ended up being ok. It would need to be flashed to your balt or HHR by the dealer or someone that can do tuning.
Arospeed intercooler style front air intake--Asking $60 plus shipping--bought for daughters balt and she bought the K&N intake instead
the item is brand new and never used.
the whole thing is 21 x 6 x 3.25 inches. the filter part is 13.5 by 5 with a 2.25 inch inlet
pm or email me thru the forum if interested in any of the items
GLWS'S tho anyways 
Thread
Thread Starter
Forum
Replies
Last Post