HHR Panel Man

iTrader: (2)

Ahh OK, I know of them.

Don't know why someone posted that ZZP has them in stock ?

Zoomer emailed me right back saying they don't have any. Still unsure when they will be getting them in.

Powell Race Parts

iTrader: (3)

Zoomer is honest; they come from overseas. They are well priced @ 75.00 not flat (fix that easily with a belt sander) and some leak at the nipple ( fix that with some epoxy or dating someone else)

HHR Panel Man

iTrader: (2)

I have a large Delta stationary Belt / Disk sander combo machine, worked great on resurfacing the $40.00 Bad Mab Header I bought from a member here so I can touch the dual pass up a bit before installing it.









My 3.1 modular pully and 60# EV6 injectors arrived yesterday from ZZP.



HPTuners I bought on here.



Table of Parts. SC is fully polished in my garage, and most of these parts have been cleaned up now and some are painted up. I am going with a full 6 rib install swapping out all the pullies to do so.





ZZP Cams in that 2.4 Head. Been Ported and I got the ARP head stud kit.









I've got more parts too just showing I am about Ready to shove them all in my HHR Panel. Sould help it scoot along just a little bit better on the road.

Powell Race Parts

iTrader: (3)

U be rockin with those parts

HHR Panel Man

iTrader: (2)

Hope so, not going all out, just a nice street cruiser is all.

Still need that ZZP Dual Pass end plate.

riceburner

iTrader: (66)

well, i finally gave up on waiting for zzp got a nice one made my member '574' tday! i know, you're doing what you gotta do. just my update and free bump haha

nwss

They all work the same and you can't see them anyways lol, have fun waiting for Zzp bump

HHR Panel Man

iTrader: (2)

I still got some time before I start the tear down, but once I do i'll just drill and weld my stock one if I have too.

So are you adding just the dual pass or adding an option b tank as well? What else are you doing to your SS?

My Pully Boys belt tool arrived yesterday.

HHR Panel Man

iTrader: (2)

Thanks for the Bump.

riceburner

iTrader: (66)

i'll be putting on the dual pass, & phelonic manifold spacer. i already have a heat exchanger. then i just gotta put on my 80# injectors and run e85 for even more cooling benefits! all that with a 2.8" pulley, intake and exhaust.

HHR Panel Man

iTrader: (2)

Sounds good. Did you see the new ZZP Stealth Heat Exchanger, I think they just posted it on their website.

It is 3x larger than stock, 70% larger than the Griffin. $399.99



Don't think I could fit it in my HHR.

HHR Panel Man

iTrader: (2)

Bump.

HHR Panel Man

iTrader: (2)

Just bought a ZZP Dual Pass End Plate that was available on here.

Paid him immediately after receiving a PM with his paypal info.



Thanks, can't wait to get it.