07blackg5

iTrader: (8)

i used factory clips along the 4 or 5 bottom tabs where the holes are pre drilled on our cars and on the front and back, and double sided tape on all of the tabs where the upper clips would be. they have been on through 2 winters and still hold tight to the rocker

Jameson

when you go to actually installing it, itll be straight forward. its all about lining it up with the holes underneath your car and common knowledge.
dont be afraid of it, use the drilling and clip method.
it took no more than 30 minutes for me to do mine.

07blackg5

iTrader: (8)

drilling is just going to rust out the rockers in no time. even if you paint it, the clips going in will most likely chip it, and they will rust like crazy. nothing is like a factory paint coating. dont **** it up

1LowLS

I'll be using the bottom clips and 3m on the sides for mine.There's no way in hell im drilling holes in my car lol

Jameson

hmmm 2 vs 1....did i say drill? i meant 3m dbl sided tape :P

c1_c1rca

i would say i wouldnt either but we all know that its already happened

klutch814

iTrader: (6)

where did you get 3m tape at? ill just do that front and rear lip is all i need now

1LowLS

woah what in the hell

c1_c1rca

really old pic, i felt adventurous..... and really high

znew

iTrader: (3)

3m tape didnt hold the skirts on at all thats why i drilled...

1LowLS

you still use the bottom clips but 3m molding tape for the side(super strong stuff)

c1_c1rca

wouldnt know never tried it

1LowLS

It was a joke lol.Lay off the bud when workin on the whip homie

znew

iTrader: (3)

you still use the bottom clips but 3m molding tape for the side(super strong stuff)[/QUOTE]

oh i know i did it didnt work for me thats why i drilled

klutch814

iTrader: (6)

where do i get the tape at

Tundraboarder666

I would drill... I have mine drilled and that's going to hold a hell of a lot better than some tape is... especially once you get going over 150 MPH.

07blackg5

iTrader: (8)

youre doing it wrong

znew

iTrader: (3)

if u say so....i feel much better with drilling holes than tape

klutch814

iTrader: (6)

i might drill like 3 then use tape?

Tundraboarder666

drill them all damn it! lol trust me it will look a hell of a lot cleaner in the end

c1_c1rca

this...........













is illegal...............

klutch814

iTrader: (6)

take a few pics for me please? haha

Tundraboarder666

Not on a track
lol



Word, tomorrow night I will take some pics. I'm studying for an exam for tomorrow morning right meow... While on CSS, I know, real productive... lol

c1_c1rca

touche sales man touche

1LowLS

Molding tape will hold just fine and sorry to say,most,if not all of our car,especially in this very thread,will never see 150 on a track unless ZZP post in here,then we have a different story.Molding tape is alot stronger than your normal 3m double sided tape.I'll be dam'd if I drill holes in my rockers.Water WILL get in there and will rust out quicker than you think and you wont even know it because you have no access to seeing the actual rocker without pulling the molding off,which breaks all your clips.Molding tape for me./argument lol
I actually talked to a guy not too long ago that used the bottom clips only with nothing on the sides and it was just as sturdy.**** drilling.**** it!!! lol